Western Telematic IPS-400 Switch User Manual


 
6-4
IPS-400 / IPS-400-CE - User’s Guide
6.2.2. On/Off/Boot/Default Commands - Text Interface
These commands can Boot or toggle the On/Off status of the IPS’s switched
plugs, or set plugs to user-defined On/Off values as specified by the
currently defined Power Up Default for each plug. Plugs may be specified
by name or number.
Notes:
Wait for the "IPS>" prompt to appear before entering additional
commands. The prompt will not reappear until the previous
command is complete.
Commands are not case sensitive. All commands are invoked by
pressing [Enter].
Users who login to command mode using a Plug password will
only be allowed to issue commands to the plugs allowed by that
password.
If command confirmation is enabled, the IPS will display the
Status Screen after the On/Off/Boot/Default commands are
successfully completed.
When On/Off/Boot commands are executed, Boot/Sequence
Delay times will be applied as described in Section 5.3.3.2.
Internet Power Switch v1.41d Site ID: (undefined)
Display Configuration
/H Display Help Screen /G View/Set General Parameters
/S Display Plug Status /P [n] View/Set Plug Parameters
/SN Display Network Status /C View/Set Serial Parameters
/N View/Set Network Parameters
Control /T View/set Telnet Parameters
/D Set Plugs to Default /W View/Set Web Server
/Boot <n> Boot Plug n /E Save Parameters
/On <n> Turn On Plug n /R Recall Parameters
/Off <n> Turn Off Plug n /DL Download Parameters to File
/X Exit/Disconnect
Utilities
+------------------------------------+ /I Reset Network Interface
| [n] = optional plug name or number | /U Upgrade Firmware
| <n> = required plug name or number |
| n+n or n n = plug n and plug n |
| n:n = plug n through plug n |
| * = all plugs |
| ,y = bypass “Sure? (y/n)” |
+------------------------------------+
IPS>
Figure 6.3: The IPS Help Screen - Text Interface