Filter
Top Products
3
1.5V LR03
UM4 “AAA”
1.5V LR03
UM4 “AAA”
1.5V LR03
UM4 “AAA”
1.5V LR6 UM3 “AA” 1.5V LR6 UM3 “AA”
1.5V LR6 UM3 “AA” 1.5V LR6 UM3 “AA”
1.5V LR6 UM3 “AA” 1.5V LR6 UM3 “AA”
Battery Requirements:
Your Roboraptor
™
is powered by 6 x “AA” size batteries (not included).
Your remote controller is powered by 3 x “AAA” size batteries (not included).
Battery Installation:
1. Before installing or changing batteries, ensure the roboraptor
™
’s
ON/OFF button is in the OFF position.
2. Remove the battery compartment covers using a Phillips or
crosshead screwdriver (not included).
3. Insert batteries (not included) into the Roboraptor
™
and controller as shown in the diagrams.
4. Replace the battery compartment covers and the screws.
Attention: Important Battery Information
• Use only fresh batteries of the required size and
recommended type.
• Do not mix old and new batteries, different types of
batteries (Standard (Carbon zinc), alkaline, or
rechargeable), or rechargeable batteries of different
capacities.
• Remove rechargeable batteries from the toy before
recharging them.
• Rechargeable batteries are only to be charged under
adult supervision.
• Please respect the correct polarity, (+) and (-).
• Do not try to charge non-rechargeable batteries.
• Do not throw batteries into the fire.
• Replace all batteries of the same type/brand at the
same time.
• The supply terminals are not to be short circuited.
• Remove exhausted batteries from the toy.
• Batteries should be replaced by adults because of
small parts.
• Remove batteries if the toy is not going to be played
with for some time.
• The packaging has to be kept since it contains important
information.
Back View of the
Remote Controller
Battery Details
Bottom View of
the Roboraptor™