Filter
Top Products
PROGRAMMING YOUR ROBOPET
™
You can program a sequence of up to 20 moves and tricks using the
controller.
1) Press Program to enter Program Mode. Robopet
™
will make a
small noise.
2) Enter movement and trick commands as usual.
a) Forward and Backward will make Robopet
™
move forward or
backward.
b) Turn Left and Turn Right will make Robopet
™
walk an arc.
c) Stop will make Robopet
™
wait for 3 seconds.
d) You can enter tricks into a program sequence, press Tricks
a number of times and press Execute to confirm the choice.
(See Trick Selection page 6, each trick will be counted as one
program step.)
3) Each time you enter a command Robopet
™
will make a small noise.
4) Press Program again to finish programming and make Robopet
™
perform the sequence.
5) If you exceed 20 steps Robopet
™
will make a small noise, press
program to perform the program.
6) To repeat the sequence press Program then press Execute or
Program again. If you enter any instructions before pressing
Execute or Program you will write over the old program with
the new sequence.
Robopet
™
will not store the program after you turn off the power or
change the batteries, but the program will stay in memory when Robopet
™
goes into Sleep Mode.
Obstacle Avoidance, Edge Detection and Fall Detection will function as
usual in Program Mode. (See Robopet’s™ Sensors on page 11, 12 & 13)
Advanced Operation
8