Filter
Top Products
1.5V
LR03
UM4
“AAA”
1.5V
LR03
UM4
“AAA”
1.5V
LR03
UM4
“AAA”
1.5V
LR03
UM4
“AAA”
1.5V
LR03
UM4
“AAA”
1.5V
LR03
UM4
“AAA”
1.5V
LR03
UM4
“AAA”
Bottom View of
the Robopet
™
Battery Installation
Battery Requirements:
Your Robopet
™
is powered by 4 x “AAA”
size batteries (not included).
Your remote controller is powered by
3 x “AAA” size batteries (not included).
Battery Installation:
1. Before installing or changing batteries,
ensure the robopet
™
’s ON/OFF switch is
in the
OFF position.
2. Remove the battery compartment covers
using a Phillips or crosshead
screwdriver (not included).
3. Insert batteries (not included) into the
Robopet
™
and controller as shown in the
diagrams.
4. Replace the battery compartment covers
and the screws.
Attention: Important Battery Information
• Use only fresh batteries of the required
size and recommended type.
• Do not mix old and new batteries, different
types of batteries (Standard (Carbon zinc),
alka line, or rechargeable), or rechargeable
batteries of different capacities.
• Remove rechargeable batteries from the toy
before recharging them.
• Rechargeable batteries are only to be charged
under adult supervision.
• Please respect the correct polarity, (+) and (-).
• Do not try to charge non-rechargeable batteries.
• Do not throw batteries into a fire.
• Replace all batteries of the same type/brand at
the same time.
• The supply terminals are not to be short circuited.
• Remove exhausted batteries from the toy.
• Batteries should be replaced by adults because of
small parts.
• Remove batteries if the toy is not going to be
played with for some time.
• The packaging should be kept since it contains
important information.
4
Bottom View of
the Controller