Filter
Top Products
4 Chapter 2
Procedures
IMPORTANT: Complete the following procedures as an administrator (administrator
privileges are required).
Step 1: Copy the RX0 Xenith Pro Conversion Image Folder (on the DVD-ROM) to Your Local
Hard Drive
Navigate to the RX0 Xenith Pro Conversion Image folder (contained on the Conversion
Software Assembly DVD-ROM) and copy it to your local hard drive.
Step 2: Install Wyse USB Firmware Tool v1.18
1. Navigate to the Wyse USB Firmware Tool v1.18_GA.exe (contained on the Conversion
Software Assembly DVD-ROM) and double-click it to execute the file and open the
WinZip Self-Extractor dialog box.
2. Enter the destination folder you want (for example, C:\USBFT) in the Unzip to folder
box, and then click Unzip to extract all files from the Wyse USB Firmware Tool
v1.18_GA.exe file into the folder. The default directory for the extracted files is Wyse
USB Firmware Tool.
CAUTION: It is not recommended to use your desktop for the destination folder as
there are several files that will be extracted from the .exe file.
3. After installation, create a shortcut on the desktop for the Wyse USB Firmware
Tool.exe file (see your operating system documentation).
Step 3: Use Wyse USB Firmware Tool to Configure a Single USB Key to Install Firmware
CAUTION: For Windows 7 Enterprise and Windows 7 Ultimate operating systems, be
sure to right-click on Wyse USB Firmware Tool.exe and select the Run as administrator
option.
1. Double-click the shortcut on the desktop for the Wyse USB Firmware Tool.exe file to
run the tool and open the Wyse USB Firmware Tool wizard (the welcome page
provides the product version and description, and a link to view the Wyse end user
license agreement).
Figure 2 Wyse USB Firmware Tool wizard
2. Click Next to open the Select an Option dialog box.