Filter
Top Products
08905153B - 10 -
Pre-Wiring
D5RH Digital Audio Distribution Hub to D5KP Amplifier Keypad
The D5RH and all associated components are wired using CAT-5 terminated to the T-568A Wiring
Standard (Figure 2.2). When pre-wiring, run lengths of CAT-5 from the pre-determined equipment
location (the “head-end”) to each Amplifier Keypad location. The CAT-5 routes all audio, power, IR
and status information needed for full system operation.
Note: For maximum performance over long runs (more than 150 ft) run an additional 16AWG 2-
conductor wire for external power.
12345678
12 34 56 78
GREEN/WHITE
GREEN
ORANGE/WHITE
BLUE
BLUE/WHITE
ORANGE
BROWN/WHITE
BROWN
Shown tab
down
Figure 2.2: T-568A Wiring Standard
Amplifier Keypad to Speakers
Run 16AWG 2-conductor stranded copper speaker wire between Amplifier Keypad locations and
speaker locations.
Local Sources to Amplifier Keypad
Local sources are only available within the area that they are installed. They will not be available to
other areas of the house as they are not distributed by the D5RH. Run lengths of CAT-5 from any
local (in-room) source to the Amplifier Keypad located in that area.