Xantech HD44CC5 Switch User Manual


 
08905071B - 3 -
[3] IR RECEIVER
The rear panel IR receiver is a 3.5mm Stereo jack that is compatible with all Xantech IR receivers,
such as the 291-10. Switch 4 must be in the OFF position to use this jack.
PLUG CIRCUIT
TIP IR SIGNAL
RING GROUND
SLEEVE +12VDC, 25mA
[4] IR BUS, EMITTER PORT
The 3.5mm Mono jack is an emitter port. The IR signal is connected to the IR Receiver. A Xantech
283M emitter can be connected to this port.
PLUG 2-Pin WECO CIRCUIT
TIP + IR SIGNAL
SLEEVE - GROUND
The 2-Pin WECO screw terminal is an IR port. The IR signal is connected to the IR Receiver. The
WECO screw terminal allows easy installation to a typical Xantech IR connecting block.
[5] RS232 (SERIAL) COMMANDS
The RS232 Port is bi-directional. The communication is set to 9600 Baud 8-N-1.
DB9 CONNECTOR
CIRCUIT PIN
TX 2
RX 3
GND 5