Filter
Top Products
Introduction
The XPL series provides medium levels of power (up to 125 watts) in a compact and attractive
case style using linear regulation.
High resolution controls allow precise setting of voltage and current levels which are indicated on
accurate and highly legible digital meters.
Excellent line and load regulation is matched by very low noise and good transient response.
Improved power efficiency ensures that the units require no fan cooling.
The XPL 30-2D has two independent isolated outputs each with a 0 to 30V, 0 to 2A capability. The
outputs operate in constant voltage or constant current mode with automatic crossover and mode
indication. Each output has its own on-off switch. The outputs can be wired in either series or
parallel to provide voltages up to 60 volts or currents up to 4 amps. The XPL 30-2T has, in
addition, an Auxiliary ‘logic voltage’ output with a 2A current capability. This output can be preset
between 1.5 volts and 5 volts via a front panel control.
The XPL 18-3, XPL 30-1, XPL 30-2 and XPL 56-1 are single output supplies capable of supplying
up to 15V/5A, 18V/3.3A, 30V/1A, 30V/2A, 30V/3A or 56V/1.1A respectively.
The XPL series incorporates separate digital voltage and current meters on each output. The
meters use bright 14mm (0.56”) LED displays and have an update rate of 4 per second providing
near instantaneous response. Simultaneous metering of voltage and current provides accurate
information “at a glance” and avoids any possibility of misinterpretation. When an output switch is
set to “off”, the current limit setting is displayed enabling conditions to be set before the load is
connected. With the right-hand main output off the right-hand meters can be used to momentarily
display the preset Auxiliary voltage and current limit.
The XPL series has been designed to meet the stringent requirements of relevant IEC standards
for safety and EMC. All outputs are intrinsically short circuit proof, and are protected against
external voltages and reverse currents.
Table of Contents
Introduction 2
Specification 3
EMC 5
Safety 6
Installation 7
Operation - Main Outputs 8
Operation – Auxiliary Output 9
Operation - General 9
Calibration 10
Maintenance 11
Instructions en Francais 12
Bedienungsanleitung auf Deutsch 17
Istruzioni in Italiano 22
Instrucciones en Español 27
Warranty Information 32
2