Filter
Top Products
U
SING
P
RINT
M
ATERIALS
3.11
3
3
When you print on envelopes, you must select Manual
Feed for Source from the software application, and then
select the correct paper size and type. For details, see
page 4.6.
4
Press the button to start feeding.
Note: Please be careful when you open the rear cover. The inside
of the printer maybe hot.
5
Printing is started. Close the rear output tray after the
printing is completed.
Printing on Labels
1
Open the rear output tray. Load labels in the manual feeder
with print side up.
Guidelines
• Only use labels recommended for laser printers.
• Verify that the labels’ adhesive material can tolerate fusing
temperature of 200°C (392°F) for 0.1 second.
• Make sure that there is no exposed adhesive material
between the labels. Exposed areas can cause labels to peel
off during printing, which can cause paper jams. Exposed
adhesive can also cause damage to printer components.
• Do not feed a sheet of label through the printer more than
once. The adhesive backing is designed for one pass through
the printer.
• Do not use labels that are separating from the backing sheet
or are wrinkled, bubbled, or otherwise damaged.