Filter
Top Products
12 MICR User Guide
NOTE: 600 dpi PCL fonts must not be used with a 300 dpi queue
or with any 300 dpi resources. The resolution mismatch causes
characters to be one dot further apart than is nominal. While this
spacing meets industry standards, a high reject rate can result if
the adjacent field spacing does not compensate for this error.
You can use the PCL Unit of Measure command to set the PCL
Unit to 600 (for example, <ESC>&u600D). Alternatively, you can
override the resolution to 600 dpi in the queue. Refer to “Setting
the font resolution,” later in this chapter, for information on setting
the resolution in the queue.