Filter
Top Products
SYSGEN AND SYSGEN-RELATED PROCEDURES
XEROX DOCUPRINT 180 LPS SYSTEM GENERATION GUIDE 4-27
Performing a mini sysgen
Use the following procedure when performing a mini sysgen.
When to use You can use the MINI command to make changes to the logical
configuration of the system, such as:
• change the configuration options of the current system
• deactivate or reactivate features and configuration options that
were installed as part of a previous full or update sysgen.
Note: Make sure the logical configuration (the features specified in
the configuration options) and the physical configuration (the
hardware that supports those features) are the same before
performing a sysgen.
If you perform a sysgen and some device in the physical
configuration is missing from the logical configuration, that device
may be unusable after the sysgen is performed.
Mini sysgen procedure summary
Table 4-6 lists the steps used to perform a mini sysgen.
Step 1. Review the configuration options provided in the “Configuration
menu” section of the “Sysgen configuration options” chapter.
Step 2. Use the MINI command to display the Configuration Options menu.
Step 3. Select or specify your desired options.