Filter
Top Products
135
Troubleshooting
LCD Error Messages
1/7/10 Xi4™/RXi4™ User Guide P1009874-002
LCD Error Messages
The LCD displays messages when there is an error. See Table 11 for LCD errors, the possible
causes, and the recommended solutions.
Table 11 • LCD Error Messages
LCD Display/
Printer Condition
Possible Cause Recommended Solution
The ERROR light flashes.
The printhead was replaced with
one that is not a genuine Zebra™
printhead.
Install a genuine Zebra™ printhead.
The printer stops; the
RIBBON light is on; the
ERROR light flashes.
In thermal transfer mode, ribbon is
not loaded or incorrectly loaded.
Load ribbon correctly. See Load
Ribbon on page 69.
In thermal transfer mode, the
ribbon sensor is not detecting
ribbon.
1. Load ribbon correctly. See Load
Ribbon on page 69.
2. Calibrate the sensors. See
Calibrate Media and Ribbon
Sensor Sensitivity on page 101.
In thermal transfer mode, media is
blocking the ribbon sensor.
1. Load media correctly. See Print
Modes and Printer Options
on page 36.
2. Calibrate the sensors. See
Calibrate Media and Ribbon
Sensor Sensitivity on page 101.
In thermal transfer mode, the
printer did not detect the ribbon
even though it is loaded correctly.
1. Print a sensor profile.See Print
Sensor Profile on page 100. The
ribbon out threshold (
1) is likely
too high, above the black area that
indicates where the ribbon is
detected (
2).
2. Calibrate the sensors or load
printer defaults. See Calibrate
Media and Ribbon Sensor
Sensitivity on page 101 or LOAD
DEFAULTS on page 87.
1
2