Filter
Top Products
16 PA/PT400 & PA/PT 403 User’s Guide
Fanfold Media (optional vibration mount required)
NOTE. If ribbon is loaded (PTseries only), remove the rib-
bon cartridge before loading the media.
1. Raise the media access door by lifting at the notch until it un-
hooks from the top cover (refer to Figure 4).
2. Swing the media access door open to expose the media com-
partment (refer to Figure 5).
3. Pivot the top cover to reveal the printhead.
4. Lift the printhead until you feel it “lock” into place. Be careful not
to force the printhead past this position!
WARNING: NEVER touch the thermal print elements on
the underside of the printhead. Under certain conditions,
they can be very hot! Also, dirt or moisture from your
hands can damage the prlnthead!
5. Separate and hold open the media hangers (refer to Figure
11).
6. Place the plastic media core (refer to Figure 11) onto the media
hangers.
NOTE. The plastic media core can be obtained from an au-
thorized Zebra supplies reseller.
7. Release the media hangers so the plastic media core locks into
the correct position.
8. Place the fanfold media in the fanfold media tray.
Media
Hangers
Media
Guides
Plastic
Media
Core
F
IGURE
11