Filter
Top Products
10
UMAN-PEP
INSTALLATION OF MEDIA
The following details media installation:
1. Turn unit off.
2. Squeeze the two finger grips on either side of the
media compartment cover. Rotate the top back to
reveal the paper compartment.
3. Drop a new roll of paper into the compartment.
Media should feed from the top of the roll and the
roll should fit between the edge guide and the right
hand wall.
The inner core on the media roll should be Ø.75” [ 19
mm] or larger to prevent the roll from jamming.
4. If using narrow media, adjust the edge guide by
snapping it into the desired slots on the printer
body. Insure the media can turn freely.
Use the table below as a guide for allowable media
widths:
Cameo PEP Media Widths
1
1.47 (37.3 mm)
1.60 (40.64 mm)
1.72 (43.7 mm)
1.85 (47.0 mm)
1.97 (50.0 mm)
2.10 (53.3 mm)
2.22 (56.4 mm)
2.35 (59.7mm)
2.47 (62.7 mm)
2.60 66.0 mm)
2.72 (69.1 mm)
2.85 (72.4 mm)
2.97 (75.4 mm)
3.10 (78.7 mm)
2
1.
All dimensions 2002 2002 mm]
2. This width available only with edge guide removed
.
5. Close the cover while holding the free end of the
media roll.
6. Insure the cover is securely latched before begin-
ning to print.