Filter
Top Products
16 port 10/100 Ethernet Switch
Connecting Computers to the Switching
Hub
After placing the Switching Hub to your desired location,
you can now start to setup your network. The first thing
you can do is to start connecting computers. You can
connect servers and workstations to the Switching
hub.
As you follow through the installation procedure in this
section, please take a close look on the connectivity
rules indicated. Make sure you follow them to setup
your network properly.
1. Connect each server or workstation to any of the
Normal ports on the Switching hub
2. To connect, plug one end of the UTP cable to the
network card on the computer and the other end to
a Normal port on the Switching hub.
When connecting a server or workstation to the
Switching hub, the cable length should not exceed 100
meters.
Connecting Computers to the Hub
1-7 connecting computers to the switch hub