Filter
Top Products
Prestige 2602HWL-DxA Support Notes
All contents copyright (c) 2005 ZyXEL Communications Corporation.
176
What are Local ID and Peer ID?
Local ID and Peer ID are used in IKE phase 1 negotiation. It’s in FQDN(Fully Qualified Domain Name)
format, IKE standard takes it as one type of Phase 1 ID.
Phase 1 ID is an identification for each VPN peer. The type of Phase 1 ID may be
IP/FQDN(DNS)/Ueser FQDN(E-mail). The content of Phase 1 ID depends on the Phase 1 ID type. The
following is an example for how to configure phase 1 ID.
ID type Content
------------------------------------
IP 202.132.154.1
DNS www.zyxel.com
E-mail support@zyxel.com.tw
Please note that, in Prestige, if "DNS" or "E-mail" type is choosen, you can still use a random string as
the content, such as "this_is_Prestige". It's not neccessary to follow the format exactly.
By default, Prestige takes IP as phase 1 ID type for itself and it's remote peer. But if it's remote peer is
using DNS or E-mail, you have to ajust the settings to pass phase 1 ID checking.
When should I use FQDN?
If yoour VPN connection is Prestige to Prestige, and both of them have static IP address, and there is no
NAT router in between, you can ignore this option. Just leave Local/Peer ID type as IP, then skip this
option.
If either side of VPN tunneling end point is using dynamic IP address, you may need to configure ID for
the one with dynamic IP address. And in this case, "Aggressive mode" is recommended to be applied in
phase 1 negotiation .
Is my Prestige ready for IPSec VPN?
IPSec VPN is available for Prestige since ZyNOS V3.50. It is free upgrade, no registration is needed.
By upgrading the firmware and also configurations (romfile) to ZyNOS V3.50, the IPSec VPN capability