Filter
Top Products
ES-1016B/1024B User’s Guide
18 Chapter 2 Hardware Description and Connection
2.2.2 Front Panel Connections
You can use unshielded twisted pair (UTP) or shielded twisted-pair (STP) Ethernet cables for
RJ-45 ports. The following table describes the types of network cable used for the different
connection speeds.
Note: Make sure the cable length between connections does not exceed 100 meters
(328 feet).
Table 1 Network Cable Types
SPEED NETWORK CABLE TYPE
10 Base-T 100Ω 2-pair UTP/STP Category 3, 4 or 5
100 Base-TX 100Ω 2-pair UTP/STP Category 5
2.2.3 Front Panel LEDs
The LED Indicators give real-time information about the status of the switch. The following
table provides descriptions of the LEDs.
Figure 6 Front Panel LEDs (ES-1024A)
The following table describes the LEDs.
Table 2 The Front Panel LED Descriptions
LED COLOR STATUS DESCRIPTION
PWR Green On The switch is on and receiving power.
Off The switch is not receiving power.
LINK/
ACT
Green On The port is connected to an Ethernet network.
Blinking The port is receiving or transmitting data.
Off The port is not connected to an Ethernet network.
2.3 Hardware Installation
Refer to the Quick Start Guide for hardware installation instructions.