Filter
Top Products
IES-5000/5005/6000 Support Notes
58
3. CFM MEP Screen
Endpoint ID: Select a valid MEP ID which is defined in the CFM maintenance association
screen.
Port: This binds the MEP ID to a physical port on the device. You can select an Ethernet port
or a DSL port.
Direction: Select whether to send CCMs (Continuity Check Messages) from the end point you
selected in this screen (down) or from another active Ethernet port (up).Select up only when
the link of the specified end point is down.
Priority: Select the priority level for the CCMs configured in this screen. “0” is the lowest
priority and “7” is the highest.
CCI-enabled: Select this to enable CCMs sending from the end point configured in this screen.
Deselect this to stop CCMs sending.
Alarm Time: This is the number of seconds the ZyXEL Device waits to send a local alarm after
three CFM_ERROR events have been defected.
Reset Time: This is the number of seconds the ZyXEL Device waits to cancel a local alarm
after a CFM_ERROR event has been resolved and no other alarms occurred.
Mac Address: Enter the CFM en point’s MAC address.
All contents copyright (c) 2008 ZyXEL Communications Corporation.