Filter
Top Products
ENGLISH
2
Follow the instructions to connect your ZyWALL.
1 Connect the WAN port to an Ethernet
jack using an Ethernet cable.
2 Connect a computer to the LAN port
with another Ethernet cable.
3 For power, do one of the following:
Note: Do NOT connect the USB and
the PWR ports at the same time.
This may damage your ZyWALL
and render it useless.
• To supply power through the USB port, connect the USB port to a
USB port on a computer using the included USB cable only.
• To supply power through the power socket, connect the PWR port to
a power supply using the included power adaptor.
After you’ve made the connections and turned on the power source, look at
the front panel LEDs.
The PWR LED turns on when you connect the power. The PWR LED blinks
while performing system testing and then stays on if the testing is
successful. The LAN and WAN LEDs turn on if the corresponding
connections are properly made.