Filter
Top Products
Chapter 5 AP Mode
NBG-417N User’s Guide
54
2 To set your NBG-417N to AP Mode, go to Maintenance > Sys OP Mode >
General and select Access Point.
Figure 24 Maintenance > Sys OP Mode > General
3 A pop-up appears providing information on this mode. Click OK in the pop-up
message window. (See Section 22.4 on page 186 for more information on the
pop-up.) Click Apply. Your NBG-417N is now in AP Mode.
Note: You have to log in to the Web Configurator again when you change modes.
5.3 Status Screen (AP Mode)
Click on Status. The screen below shows the status screen in AP Mode.
Figure 25 Status Screen (AP Mode)