Filter
Top Products
Chapter 2 Introducing the Web Configurator
NXC-8160 User’s Guide
30
2.3.4 Navigation Panel
Use the sub-menus on the navigation panel to configure NXC-8160 features.
The following table describes the sub-menus.
2.3.5 About Screen
The About screen displays firmware information. To display the screen as shown below, click
the about ( ) button.
802.11 Mode This shows the wireless standard (IEEE 802.11a, b or g) you configured for the
radio (wireless transmissions of signals).
If Radio 2 is disabled, this displays Inactive.
Channel This shows the channel number you configured for the radio.
SSIDs (vlan) This shows the SSID (Service Set IDentity) and the VLAN ID number (if
configured) for the radio.
Other SSIDs This shows the configured SSIDs (if any) which are not assigned to a radio.
Table 3 Web Configurator Status Screen (continued)
LABEL DESCRIPTION
Table 4 Screens Summary
LINK TAB FUNCTION
Status This screen shows the NXC-8160’s general device and network
status information.
LAN LAN Use this screen to configure LAN TCP/IP settings.
WLAN WLAN
Configuration
Use this screen to configure your WLAN settings for a radio and
create new SSIDs.
SSID Table Use this screen to rename an SSID.
SSID & Security Use this screen to configure the wireless LAN settings and WLAN
security settings for an SSID.
Advanced Use this screen to set up an alternative NXC-8160 as a backup in
case the primary NXC-8160 fails. You can also use this screen to
send SNMP traps to an SNMP manager.
Access Points Use this screen to view which AP is active and decide whether to
send power to an AP.
Maintenance Maintenance Use this screen to change your NXC-8160’s time and date, upload
firmware to your NXC-8160, backup and restore the configuration
or reset the factory defaults to your NXC-8160. This screen also
allows you to reboot the NXC-8160 without turning the power off.
Syslog &
Monitor
Use this screen to enter the IP address of your syslog server and
monitor server.
Password Use this screen to change your system passwords.