Filter
Top Products
Chapter 7 LEDs and Troubleshooting
PLA-4xx Series User’s Guide
68
V The PLA-4xx Series Configuration Utility does not display all or any of my
devices.
• Inspect the LEDs on your PLA-4xx and make sure that the ETHERNET and HomePlug
LEDs are on or blinking. See Section 7.2 on page 65 for troubleshooting LED related
problems.
• Check all ZyxEL HomePlug AV devices on your network have the latest firmware
installed. The latest utility cannot communicate with PLA-4xxs using earlier versions of
the firmware. Go to Section 5.4 on page 44 for instructions on installing the latest
firmware.
• Check you are using the latest version utility. Earlier version utilities cannot communicate
with PLA-4xxs using the latest firmware. If you do not have the latest utility, download it
from the ZyXEL website.
• If the device is not a ZyXEL device, then the DAK and Network Name will be greyed out.
• If you are running another tool such as the Firmware Detection Tool or Firmware
Upgrade Tool, the Utility will not detect your local device.
7.4 Powerline Problems
V The signal on my powerline network is weak.
1 Your powerline adapters may be connected to electrical surge protectors. Connect them
to standard power outlets.
2 Your powerline adapters may be located close to large appliances such as refrigerators or
air-conditioners that cause interference with the powerline signal. Move the adapters
further away from such appliances to reduce interference.
3 Your powerline adapters may be placed close to electrical devices such as electrical
insect-killers which produce radio waves. These may interfere with the powerline
signals. Move the adapters further away from such electrical devices.
4 Your wiring may be old and/or low quality or with a long wiring path.
7.5 ENCRYPT Button Problems
This section applies only to PLA-4xxs with the ENCRYPT button.
V The HomePlug light is already on, but I haven’t pressed the ENCRYPT button
yet.
Your device has already connected to another powerline device. Press the ENCRYPT button
for more than 10 seconds to release the connection.