68 CHAPTER 6: STANDARD FEATURES
To prepare the headset for all calls on the Model 3102 Business
Telephone:
1 Plug the headset connector into the headset jack on the underside of the
telephone.
2 Press the Headset button. By default, this button is the Access button
just below the Program button at the top right corner of the telephone.
3 Verify that the indicator light next to the Headset button comes on.
To answer a call when you are using the headset:
1 Put the headset on. When a call comes in, press the System Appearance
button beside the flashing light. You are connected to the call.
The handset can be either on hook or off hook.
2 To end a call when you are using the headset, press the Release button
on the telephone. By default, the Release button is located at the
bottom of the right column of Access buttons.
Returning to the
Headset After a
Long
Delay
Certain brands of headsets enter a power-saving mode that prevents the
telephone from ringing for one or more calls when both of these
conditions are true:
■ The headset amplifier buttons for Mute and On are both set to On.
■ The handset is off the phone for a long time (for example, overnight).
It may take a few minutes for your headset to return from the
power-saving mode to the active mode when calls first come in, so your
telephone may not ring until the headset has returned to active mode,
and you may miss a call.
If you plan to not use the headset for a long time, 3Com recommends
that you set the mute and headset buttons on the amplifier to Off and
hang up the handset on your telephone. When you are ready to receive
calls again, set up the headset for receiving calls:
1 Pick up the handset on your telephone and set it on your desk.
2 Put on the headset.
3 On the amplifier, set the headset button to On.
