NOTE: When lift is not in use, lifting arm should be stored in the fully retracted position. Keep lift clean and well
lubricated. Apply a couple of drops of light machine to all pivoting joints as needed. Thoroughly wipe up excess
oil to help prevent slipping and falling.
1. To check hydraulic oil level, remove unit from lift, stand unit upright on a stable, level surface. Remove oil filler
plug. Oil should be to the level of the oil filler plug hole.
2. If low, add high quality hydraulic jack oil ONLY. Never use ANY other fluid. Use of other fluid may result in
hydraulic system failure, causing sudden and unexpected loss of load height.
3. Install oil filler plug, install hydraulic unit into receiver of lift. Secure with provided bolt.
NOTE: To get the longest life possible out of your lift, we recommend changing the hydraulic oil after 7 years of
use, sooner if used in a dust and grit filled environment. Do not expose to moisture. Dry lift completely if it gets
wet. Check pump piston and ram of hydraulic unit periodically for signs of rust and corrosion. Clean mildly
affected areas with a clean oily cloth. Never use abrasives on the pump piston and ram surfaces.
1. Remove hydraulic unit from lift. Stand unit upright on a stable, level surface. Remove oil filler plug and drain
old oil into a suitable container.
2. Fill with high quality hydraulic jack oil.
NOTE: Dispose of used hydraulic oil in accordance with local regulations.
1. Fully lower the lift arms, leave release valve open.
2. Remove oil filler plug. As you remove the oil filler plug you may hear a pressurized air escaping from the
reservoir. This means you have successfully purged trapped air from the system.
3. Install oil filler plug.
CARE AND MAINTENENCE
!
!
TO CHECK AND ADD HYDRAULIC OIL
!
!
TO REPLACE HYDRAULIC OIL
!
!
TO PURGE TRAPPED AIR FROM SYSTEM
!
!
REPLACEMENT PARTS LIST
1. Front Wheel Assy. (1 ea.)
2. Rear Caster Assy. (1 ea.)
3. Hydraulic Unit Assy.
4. Locking Lever Assy.
5. Handle
6. Complete Hardware Kit (Not Shown)
Front Wheel Assy.
Handle
Rear Caster Assy.
Locking Lever Assy.
Hydraulic Unit Assy.
4
