Rev. 3.02
- 80 -
SRP-270
8-8-2-3 Base Paper Feed Assy - #3
Name of Parts Method and Procedure
①SUB PCB ASSY
②SCREW TAPPING (M2*3, 2EA)
③MANUAL CUTTER
④SCREW (M3*6, 2EA)
⑤PLATEN PAPER GUIDE
⑥SHAFT HOLE ROLLER
⑦HOLE ROLLER (2EA)
⑧SPRING HOLD ROLLER (2EA)
1. Set SUB PCB ASSY to fit the hole in the bottom face of ①
BASE PAPER FEED and tighten two SCREW TAPPING.②
2. Set the MANUAL CUTTER to the boss on the BASE ③
PAPER FEED and tighten two SCREW.④
3. Hook PLATEN PAPER GUIDE on the manual cutter in the ⑤
front face of BASE PAPER FEED.
4. Grease section of SHAFT HOLE ROLLER mounted HOLE ⑥
ROLLER and insert two HOLE ROLLER⑦ . Next, set SHAFT
to the each groove of BASE PAPER FEED as fitting HOLD
ROLLER into PPG.
5. Hook two SPRING HOLD ROLLER⑧ on the both side of
BASE PAPER FEED.
<Check Point>
Check the location of PLATEN PAPER GUIDE, status of
hooking, coming off.
