A SERVICE OF

logo

Rev. 3.02
- 81 -
SRP-270
8-8-2-4 Main assembling - #1
Name of Parts Method and Procedure
FRAME MAIN C/K ASSY-4
SERIAL NO. TAG
TAPE INSULATION
LEVER COLOR CHANGE
SOLENOID ASSY
SPRING SOLENOID
SCREW MACHINE (M2*3)
GEAR PULLEY ASSY
WASHER (ø2.6*5*0.5)
LEVER TENTION BELT ASSY
SCREW (M3*4)
1. Set FRAME MAIN C/K ASSY -4 on the JIG.
2. Paste SERIAL NO. TAG in the right side and TAPE ②③
INSULATION on the bending line in the bottom face.
3. Grease SHAFT(6 point) with HG-31S.
4. Insert LEVER COLOR CHANGE into SHAFT in the left
bottom side and fit WASHER(2.6*8*0.5).
5. Turn SOLENOID ASSY and SPRING SOLENOID
downward and insert it into the hole of LEVER C/C and M/F
side step by step. Next, tighten SCREW MACHINE.
6. Insert GEAR PULLEY ASSY and then, fit WASHER .
7. Insert LEVER TENTION BELT ASSY to the hole and then,
tighten SCREW two-third.