Indoor Pendant & In-ceiling Models | Instruction Manual | Installation
Bosch Security Systems | 10 December 2003
EN
|
11
Photo 6: Align Red Dots
3. While holding the trim ring, gently insert the
camera module into the housing until you feel some
resistance. The unit should be only an inch or so
from being completely inside the housing at this
point.
Photo 7: Insert Camera Module
4. Now, simply press the rest of the way while twisting
clockwise until it stops turning, at which point you
should feel a slight click (approximately 1/8th of a
turn). See PHOTO 8.
Photo 8: Turn Camera Module into Place
5. With a small slotted screwdriver, tighten the locking
screw located in the trim ring. This will prevent the
trim ring from being inadvertently loosened.
Photo 9: Tighten Locking Screws
6. The BasicDome is now installed; the next step is to
set it’s address via FastAddress. These instructions are
found in SECTION 4.
Photo 10: Installed BasicDome
Red Dots
