Indoor Pendant & In-ceiling Models | Instruction Manual | Installation
Bosch Security Systems | 10 December 2003
EN
|
9
1UNPACKING
Carefully remove the BasicDome camera module from
the box. This camera module is the same one used in
both the pendant and the in-ceiling models. The
additional parts required for pendant or in-ceiling
mounting are shipped in a separate box. Inside this
box you should find the camera module, this
instruction booklet with User Manual insert, and an
optional, alternate colored trim ring.
Also included in the box is a small ferrite (not shown)
which snaps onto the power cable, providing additional
EMI/RFI Interference protection.
Photo 1: Contents
2INSTALLATION
ATTENTION: Installation should be
performed by qualified service personnel only,
in accordance with the National Electrical
Code or applicable local codes. Refer to
applicable installation section.
The BasicDome can be mounted to a wall, mast (pole),
roof, pipe, corner, or suspended ceiling. You must have
installed the appropriate mount before installing the
BasicDome. Each mount includes its own instructions.
Once the mount is installed and wired according to
those instructions, proceed to the next step. For
suspended ceiling installations, proceed to STEP 2.4.
CAUTION: Mounts must be properly and
securely installed on a supporting structure
capable of sustaining the unit weight.* Use
care when selecting mounting hardware (not
supplied) for installation. The mounting
surface and the unit's weight should be
carefully considered.
The following instructions reference a 24 VAC pendant
arm installation mounted to an existing structure. The
instructions assume the power, video, and control
cables have already been properly installed.
*Refer to mounting instructions.
NOTE: SECTIONS 2.1, 2.2, and 2.3 refer to
the Pendant Housings ONLY.
2.1 Installation (Pendant Housings)
For pendant models, the mount should already be
installed according to the specific mounting instructions
included with the mount. Mounts come with screws
installed that are used with other dome products, and
should be removed and discarded. A safety cable may
be included, but is not used with the BasicDome, and
should be removed and discarded to avoid possible
contact with the PC board inside the pendant.
Photo 2: Remove Existing Screws
