Setting Up the FaxPress Premier Analog
13
3. By default, the FaxPress Premier is DHCP-enabled. Powered on
in a DHCP (Dynamic Host Configuration Protocol) environment,
the Premier will automatically be assigned an IP address from
your network’s DHCP server, but will need to be manually joined
to the network domain. The Premier’s IP address will be dis-
played on the FaxPress Premier’s front panel LCD window.
4. Plug the power cable into the FaxPress Premier server.
5. Plug the power cable into a power source.
6. Power on the FaxPress Premier. (See
Powering on the FaxPress
Premier Server on page 21 of this guide
.)
Attaching the Premier Analog to your Fax Lines
Each Premier Analog fax modem board provides four fax line interfaces.
Every two lines share one RJ-14 connector on the fax modem board.
Each RJ 14 uses one of the provided external "Y" cables with a RJ-11
plug at each of the two split ends to connect to two phone lines.
FaxPress Premier Analog comes with the split cables to be used to attach
FaxPress Premier Analog to the analog fax line. Each split cable can
connect to two RJ-11 ports.
If FaxPress Premier Analog is connected behind a PBX and automatic
inbound fax routing will be implemented, you’ll need to know the input
string of DTMF digits from the PBX to the FaxPress Premier Analog fax
line. A mask will need to be configured for FaxPress Premier Analog to
recognize the input string. See
Automatic Routing in the
Administrator’s Guide for information.
