A SERVICE OF

logo

Open as PDF
next previous
5
1311 12 14 15 16 17 18 19 20 21
19: DSP MODE: Use this control to select one of the 16 built-in digital effects. A listing of the effects is shown on
page 3 of this manual.
20: LIGHTS: Use this switch to turn the front panel illumination on (top of the switch depressed) and off (bottom
of the switch depressed). This switch is only operative when the Power switch (#21) is at the on position.
21: POWER: Use this switch to turn the amplifier on (top of the switch depressed) and off (bottom of the switch
depressed).
GLX1200H
Guitar Amplifier with
DSP
& ChannelTracking
Made in the U.S.A. By SLM Electronics
1400 Ferguson Ave./St. Louis, MO 63133
CLEAN/
SOLO/RHYTHM
SPEAKER
OUTPUT
120 WATTS
@
4 OHMS
4 OHMS MINIMUM
EFFECTS
RETURN
EFFECTS
SEND
DSP
FOOTSWITCH
CAUTION:
TO REDUCE THE
RISK OF FIRE,
REPLACE FUSE
WITH SAME TYPE
AND RATING.
CAUTION
AVIS:
RISQUE DE CHOC
ELECTRIQUE. NE PAS OUVRIR.
RISK OF ELECTRIC SHOCK
DO NOT OPEN
WARNING: TO REDUCE THE RISK OF
FIRE
OR ELECTRICAL SHOCK, DO NOT EXPOSE
THIS
EQUIPMENT TO RAIN OR MOISTURE.
22 2423 25 26 27 28
The Rear Panel:
22: FUSE: The fuse protects the amplifier from damages caused by a faulty AC power source and/or
other problems. If the fuse opens, replace it ONLY with the same size and type. If fuses continue to
fail, check the AC source – if the source is okay, contact your Crate dealer for service information.
23: AC LINE CORD: This grounded power cord is to be plugged into a grounded power outlet, wired
to current electrical codes and compatible with the voltage, power, and frequency requirements stat-
ed on the rear panel. Do not attempt to defeat the safety ground connection.
24: CLEAN/SOLO/RHYTHM FOOTSWITCH JACK: Use this jack to connect the 1/4” stereo plug on
the footswitch cable to the three-button footswitch (supplied). This allows you to remotely switch
between the Clean and Distortion channels and between the Solo and the Rhythm channels.
25: DSP FOOTSWITCH JACK: Use this jack to connect the 1/4” mono plug on the footswitch cable
to the three-button footswitch (supplied). This allows you to remotely turn the DSP function on and off.
26. SPEAKER OUTPUT: Use this jack to connect the amplifier to a speaker cabinet (or multiple cab-
inets). The minimum total impedance of the speaker cabinet(s) is 4 ohms.
27. EFFECTS RETURN: Use this jack to connect the signal from an external effects device to the amplifier.
28. EFFECTS SEND: Use this jack to connect the signal from the amplifier to an external effects
device for processing.