Using the System Setup Program | 121
Requests a optimal default of SETUP values on the next
boot.
System does not provide legacy USB support for operating
system.
System provides legacy USB support for operating system.
Sets the 1st Serial ATA drive controller to OFF.
Sets the 1st Serial ATA drive controller to Auto (enabled if
present, POST error if not present).
Sets the 2nd Serial ATA drive controller to OFF.
Sets the 2nd Serial ATA drive controller to Auto (enabled
if present, POST error if not present).
Sets the 3rd Serial ATA drive controller to OFF.
Sets the 3rd Serial ATA drive controller to Auto (enabled if
present, POST error if not present).
Sets the 4th Serial ATA drive controller to OFF.
Sets the 4th Serial ATA drive controller to Auto (enabled
if present, POST error if not present).
Sets the 5th Serial ATA drive controller to OFF.
Sets the 5th Serial ATA drive controller to Auto (enabled
if present, POST error if not present).
Sets the 6th Serial ATA drive controller to OFF.
Sets the 6th Serial ATA drive controller to Auto (enabled
if present, POST error if not present).
Disables the SATA controller. The token applies to the
first on-board SATA controller.
Enables the SATA controller. Sets the device class code as
IDE and uses PCI IRQ (referred as Native mode). This
token applies to the first on-board SATA controller.
Enables the SATA controller. Sets the device class code as
SATA and sets up the AHCI BARs and registers. This
token applies to the first on-board SATA controller.
