BI-39077 GETTING STARTED
8
2. Type: “CD”, press the Space bar, type: “GTICON” (or whatever other name was given to the directory where the
GTI Configurator software files were installed) and press the Enter key. The characters C:\GTICON>_ (or
C:\whatever>_) should then be displayed on the next line of the screen.
3. Type: “GTICON”, press the Enter key, and wait until the Main Menu screen appears. (If passwords have been
assigned, you will need to enter your password in the password screen before the Main Menu screen appears.)
KEYBOARD COMMANDS
The GTI Configurator program responds to keyboard commands only - no mouse. Therefore, entry to and exit from all
screens, windows, and fields must be done with keys or combinations of keys. Table 1 shows the responses to expect when the
listed keys (or key combinations) are pressed while the cursor (blinking short vertical bar) is in the various windows. The
index windows will be labeled INDEX on the screen. The data windows will be labeled SYSTEM_CONFIG, TELCO
CONFIGURATION, or DID NUMBERS on the screen. The responses of these keys in other windows are similar to those
listed for the data window, although some keys may not apply and therefore have no effect.
Table 1 - Key Responses
KEY NAME INDEX WINDOW DATA WINDOW
Enter or Return Move to data window Enter typed data into field and move to next data field
Up Arrow or Previous record Previous data field
Down Arrow or Next record Next data field
Left Arrow or Previous index field Back one character
Right Arrow or Next index field Forward one character
Home Top of index window Top of data window
End Bottom of index window Bottom of data window
Page Up or PgUp Back one index window Previous data record
Page Down or PgDn Forward one index window Next data record
Insert or Ins Insert new data record Insert one character
Delete or Del Delete data record Delete one character
Tab Next index field Enter default data and move to next data field
Back-Tab Previous index field Enter default data and move to previous data field
Escape or Esc Back to main menu Back to index window
Backspace Previous index field Back one character
F1 to F10 F1=Guide info on Fn keys F1=Guide info on Fn keys
Shift-Fn No effect Fill fields with template n
Alt-Fn No effect Assign fields to template n
Note: to use the arrow keys on the numeric keypad, make sure that the Num Lock key is off.
When the message “Guide Window: F1” appears in the HELP window, a GUIDE window can be toggled in and out of view
by pressing the F1 key. This GUIDE window describes which function keys (F1 through F12) are accessible at that time and
their function.
MAIN MENU SCREEN
The Main Menu screen is the first screen displayed after you start running the GTI Configurator software. (If passwords have
been assigned, you will need to enter your password in the password screen before the Main Menu screen appears.) The Main
Menu screen contains the following five parts:
• The
software identification line
is located across the top of the screen, and identifies the name and version of the
software. The security level is displayed at the right end of the line (level 4 is identified as SUPERVISOR mode).
• The
group menu line
is located below the software identification line, and lists the five operational groups that can
be selected.
