PA 300 Peaking Amplier • Installation and Operation
Installation and Operation, cont’d
2-6
Through-desk mounting
Mount the PA 300 through a desk or table, using the optional
mounting kit (part #70-077-02), as illustrated below.
Through-desk mounting the PA 300
1. Install the brackets as shown above. Tighten the screws
only enough to allow sliding of the brackets.
2. Mark the opening through which the unit will be mounted
— approximately 1.8" by 8.9" (4.6 cm by 22.6 cm).
3. Cut out the material from the installation area.
4. Hold the unit, with the mounting brackets attached, under
the furniture where it will be secured. Mark where the
screws will attach the mounting bracket to the underside
of the furniture.
5. Drill pilot holes 1/4" (6.4 mm) deep and 3/32" (2.4 mm)
in diameter in the desk or table at the locations marked in
step 4.
6. Using the four provided wood screws, attach the brackets
to the mounting surface.
7. Slide the unit up and down or back and forth in the
mounting brackets until the face of the PA 300 is at the
desired height. Tighten the screws that secure the brackets
to the unit.
