6
6
6
Assembly
9
Screw Retainer - 2
#10 x 2.2 cm Black Screw - 2
• Position a frame so that the decorated side is outward.
• Insert the back leg of a frame into the back base.
• Fit a screw retainer over the hole in the back base, as shown.
• Insert a #10 x 2.2 cm black screw through the screw retainer
and back base. Insert the back leg of a frame into the back
base. Tighten the screw.
• Repeat this procedure to attach the other frame back leg
to the other side of the back base.
Hint: The #10 x 2.2 cm black screws may have been assembled to the
screw retainers.
Frame Back Legs
Frame Decorated Side
Back Base Hole
Screw Retainers
Back Base Hole
10
• While pressing the levers on the seat height adjusters, lift them
to position 4 on the frame front legs, as shown.
Seat Height Adjusters
Position 4
Press Lever
11
• Fit the seat assembly between the two frames.
• Insert the seat bottom tubes into the sockets in each seat
height adjuster.
Hints:
• Be sure the seat height adjusters are in the same position (position 4).
• You may need to push the frames apart slightly to fit the seat bottom
tubes into the seat height adjuster sockets.
Seat Bottom Tubes
Sockets
Seat Assembly
