Furuno DS-60 Manual

A SERVICE OF

next previous

1. INSTALLATION

1-19

3) Pass the cable through the cable gland as shown below.

4) Put the flush mounting sponge to the flange from the rear side of the DS-600.

5) Open the front cover of the DS-605 and connect the ground wire attached inside the DS-

605 to the ground terminal on the rear of the DS-600.

6) Connect the cables to the DS-600. Refer to chapter 2.

3. Remove each binding head screw from four corners of the DS-605 and set the D-600 to the

DS-605.

4. Apply silicon grease to the binding head screws and fix the DS-600 to the DS-605 with four

binding head screws.

5. Tighten the clamping glands to fix the cables.

6. Apply the putty to the cable glands for waterproofing.

7. Connect the ground terminal for the DS-605 to the ground terminal on the hull with the IV-1.25

sq. wire.

Washer*

Gasket*

TTYCYS-4 cable

{

Clamping gasket

*: Attached inside the cable gland