19
WATER SOFTENER DISINFECTION
support bacterial growth nor will these materials contaminate
-
ing shipping, storage, and installation indicate the advisability
solutions are available
the dosage accordingly.
1. Dosage:
mineral (see page 30).
a. Proceed with the normal regeneration. Press regen
regeneration.
a. Remove brine tank cover.
b. Scoop out as much old salt as possible.
c.
brine tank.
g. Using clean water and a brush or rag, wipe and rinse inside
plate is used and it is damaged or cracked, replace with
new one.
i. Put brine tank in place making sure there is no debris or
was removed earlier unless it is clean and not mushy.
We recommend using new salt.
page.
n. Put on brine tank cover.
MISCELLANEOUS
WATER SOFTENER DRAINING PROCEDURE
must be properly drained also. A simple way to properly drain
to complete the backwash cycle (this will clean the media)
and start into the brine-draw cycle. Allow the regeneration
to continue in the brine draw cycle until the brine is drawn
begins.
rinse process).
in the brine draw cycle.
that was drawn into the mineral tank out to drain through
the control valve drain line. (An air compressor blow gun
attachment with a portable air compressor works well.)
CAUTION: You do not want to apply any more pressure than
-
-
mineral tank.
CAUTION:
be sure to leave the drain valve open until you start the system
up again.
and cause any damage and does not have to be drained any
brine tank at this time. See brine tank cleaning instructions.
(#2 in Miscellaneous section, below)
6) CAUTION:
inlet/outlet water supply piping is properly drained. Depending
control valve, a water loop or trap may have been created.
-
tem and open the inlet/outlet valve(s) to allow all the water to
the plumbing system is drained.
to the start-up procedures on page 9 when you are ready to
