16 2 - Installing accessories ENWW
6 Align the DIMM so that the notches on the lower edge line up with the raised marks in the
DIMM slot.
7 Insert and press the DIMM into the slot until the DIMM snaps into place.
8 Replace the side cover.
9 Connect the power cord and any cables, and turn on the printer.
10 Enable the DIMMs in the printer driver. See Enabling accessories in the printer driver.
To verify that the DIMM is installed correctly
1 Make sure the power cord and any cables are connected and the printer is turned on.
2 Make sure that
READY appears on the control-panel display. If an error message appears,
a DIMM might have been installed incorrectly.
3 Print the printer configuration page. In the memory section, compare the memory amount
with the amount on the configuration page that you printed before installing the DIMM. If
the amount of memory has not increased, one of the following problems might have
occurred:
• The DIMM might not be installed correctly. Remove the DIMM and repeat the
installation procedure.
• The DIMM might be defective. Try a new DIMM.
