Removal and replacement procedures 43
To replace the component, reverse the removal procedure.
Media blanks
To remove the component:
1. Power down the server (on page 29).
2. Open or remove the tower bezel ("Front bezel" on page 30).
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays
are populated with either a component or a blank.
3. Remove the media blanks.
NOTE: HP recommends that you remove all media blanks to facilitate drive installation.
Retain the blanks for future use.
To replace the component, reverse the removal procedure.
Half-height or full-height media devices
To remove the component:
1. Power down the server (on page 29).
2. Do one of the following:
• Unlock and remove the bezel ("Front bezel" on page 30).
• Extend the server from the rack (on page 29).
3. Remove the access panel ("Access panel" on page 31).
