33
initio
®
4 In the INSTALL FROM DISK window that is displayed, enter the Initio Driver path name:
Insert INI-9XXXU/9XXXUW DRIVER DISK 1 into drive A:
Type: A:\WINNT, select OK
5 Select Initio INI-9XXXU/UW PCI SCSI Host Adapter, select OK to install the
INI910U.SYS driver onto your hard disk drive.
6 In the WINDOWS NT SETUP window that is displayed, enter the Initio Driver path
name to continue:
Type: A:\WINNT, select CONTINUE
7 This completes updating the Host Adapter Driver. Follow the on-screen directions
to restart you computer and activate the new driver
8 It is highly recommended that you verify Initios Windows NT device driver has been
properly installed by selecting MY COMPUTER from the desktop. Then select
CONTROL PANEL:
Select SCSI ADAPTERS from within the CONTROL PANEL group,
Select Initio INI-9XXXU/UW PCI SCSI Host Adapter from within the SCSI
CONTROLLER listing. If This device is working properly is displayed on your
screen, the driver has been correctly installed.
Installing a new Windows NT system and Initio driver
without floppy disks
For computer systems installing or upgrading to Windows NT from a floppyless setup such
as a share on your network, these instructions will guide you through the INI-9XXXU/
9XXXUW host adapter driver installation. The Windows NT drivers are located on the INI-
9XXXU/9XXXUW DRIVER DISK 1
. It is important that the hardware has been installed
successfully before proceeding further.
1 Execute a floppyless setup as described by the Windows NT System Administrators Guide
2 When SETUP begins to load, the screen will turn from black to blue with the text SETUP
IS INSPECTING YOUR COMPUTERS HARDWARE CONFIGURATION at the top
Press the F6 key to interrupt this process. You will have two seconds in which to
press this key
Microsoft Windows NT Driver Installation
