A SERVICE OF

logo

Open as PDF
next previous
12-28 FIN AL DRIVE
Front Axle
○
Tighten the boot band [A] and bend the tangs [B] securely
to hold down the end of the band.
•
Place the special grease tube nozzle in the bore of the
housing and squeeze the tube [A] until the grease comes
out from the joint bearing.
•
Tap the shaft end [A] straight with a plastic hammer until
it is locked by the circlip.
•
Squeeze all of the special grease [ A] into the new boot
[B], and slide the boot onto the outboard joint [C].
•
Compress the axle assembly to the specified length while
relieving the air pressure inside the inboard boot.
•
Hold the axle at this setting.
Standard Length of Assembling:
Right Front Axle: 178.6 mm (7.03 in.) [A]