8.89-cm (3.5-inch) form factor drive. In addition, two 6.35-cm (2.5-inch) boot drives
can be installed in the boot drive module.
Note:
A bay is defined as the space required to house a single 2.54-cm (1.0-inch)
high 8.89-cm (3.5-inch) disk drive in its carrier module (limitation of 1 TB
size).
At the rear, the chassis assembly accommodates one PSU and a server board
subsystem.
A top cover on the enclosure provides access to the cooling fans and the server
board subsystem.
Note:
The enclosure cover should only be removed by qualified service personnel
as it provides access to a service area. Upon replacement, the cover MUST
be secured by tightening the lock mechanism to the locked position with a
screwdriver.
Server board subdivision
The server board subdivision consists of:
v An Intel Server Board S5000PSL
v Slots for up to six low-profile 1.905-cm (3/4-inch) PCI cards, installed in a
vertical orientation. The following PCBs are installed as standard configuration:
– An Intel RAID Controller SRCSATAWB, in the left-hand slot (when viewed
from the rear)
v A boot drive module, which contains two 6.35-cm (2.5-inch) SATA boot drives
Server board I/O panel
The server board I/O panel consists of various connectors and LEDs.
Figure 6. Locking the enclosure cover
Figure 7. Server board I/O panel connectors
6 User Guide
