Planning and configuring your installation
Refer to “Planning your installation” on page 13 for information on overall system
configuration requirements.
Refer to the Secure Managed Client (SMC) - Storage Array Setup Poster that shipped
with your system for instructions on installing the processors, drives, and memory.
Rack installation prerequisites
The SMC - Storage Array is designed for installation into an industry standard
48.26-cm (19-inch) cabinet capable of holding the unit.
v Minimum depth: 70.76 cm (27.83 inches) from rack posts to maximum extremity
of enclosure (excludes rear cabling).
v Weight: up to 30 kg (66.20 lb), dependent upon configuration, per enclosure.
v A minimum gap of 2.54-cm (1-inch) clearance is required between the rack cover
and front of drawer. A 5.08 cm (2-inch) rear clearance between rear of drawer
and rear of rack is recommended to maintain correct airflow around the
enclosure.
v The rack should present a maximum back pressure of 0.5 mm (5 pascals) water
gauge.
Figure 14. Unpacking the SMC - Storage Array
Chapter 3. Getting Started 15
