LXE E-EQ-MX2DKOG-B Manual

next previous

Single Dock 3

E-EQ-MX2DKOG-B MX2 Docking Station User’s Guide

Using the Single Dock

Note: The Power LED on the dock is illuminated when the dock is receiving AC power. MX2

batteries will not charge unless the Power LED is on.

Place the MX2 in the dock with the keypad facing out (on the same side as the indicators).

The dock will begin charging the batteries. The MX2 can begin communicating with the host (if

the dock is cabled to the host).

Please refer to the “MX2 Reference Guide” for instructions on sending data to and from the host.

Attaching the Single Dock to a Computer

Complete the following steps:

1. Attach the 25-pin end of the cable to the Cable Connector on the back of the Single Dock.

2. Attach the other end of the cable to a serial port on your computer.

3. If you ordered the optional power adapter, attach it to the Power Input Jack on the Single

Dock .

Figure 2 Back Panel of the Single Dock

1 Power input jack

2 Cable connector