Turning on the Power
4
4-2
3. Turn on the unit’s power. You are now in the STOPPED Display Mode (refer
to Figure 4-1). The motor and the pump(s) are stopped. The display flashes,
indicating that the pump motor is waiting for you to do something. The non-
flashing, green LEDs indicate the tubing inlets (refer to Section 5.2), but fluid is
not flowing.
Figure 4-1. STOPPED vs. RUNNING Display Modes
4.4 The RUNNING Display Mode
Figure 4-2. RUNNING Display Mode
To enter the RUNNING Display Mode, do the following:
1. From the STOPPED Display Mode, press the START/STOP key. You are
now in the RUNNING Display Mode. Refer to Figure 4-2. The pump
motor starts. The attached pump(s) begin pumping fluid. The display is not
flashing. The green LEDs flash and point to the tubing inlets.
2. Press the START/STOP key again. The pump motor stops. Fluid stops
dispensing. You return to the STOPPED Display Mode.
