9
Powerware
®
3115 User’s Guide www.powerware.com
CHAPTER 3
OPERATION AND CONFIGURATION
This section covers:
Turning the UPS on and off
Starting the UPS on battery
Standby mode
How to set DIP switches
Configuring the communication port
Turning the UPS On
To turn on the UPS, press the button on the front panel (shown in
Figure 2 on page 5). After the UPS is turned on, it conducts a self-test
and enters Normal mode. The Power On indicator illuminates indicating
that power is available from the rear receptacles.
Starting the UPS on Battery
To turn on the UPS without using utility power, press and hold the
button for three seconds. When the UPS starts on battery, it does not
conduct a self-test to conserve battery power.
NOTE The UPS does not automatically detect the input frequency when starting on
battery.The default frequency for120V modelsis 60 Hz; the default frequency for 230V
models is 50 Hz.
Turning the UPS Off
To turn off the UPS, press the button on the front panel and then
unplug the UPS from the power source. If you do not unplug the UPS, it
remains in Standby mode.
