Advanced Configuration AP-700 User Guide
Alarms
78
TFTP Trap Group
Image Trap Group
SNTP Trap Group
In addition, the AP supports these standard traps, which are always enabled:
RFC 1215-Trap
Bridge MIB (RFC 1493) Alarms
All these alarm groups correspond to System Alarms that are displayed in the System Status Screen, including the traps
that are sent by the AP to the SNMP managers specified in the Alarm Host Table.
Alarm Host Table
To add an entry and enable the AP to send SNMP trap messages to a Trap Host, click Add, and then specify the IP
Address and Password for the Trap Host.
Trap Name Description Severity Level
oriTrapTFTPFailedOperation TFTP operation failed Major
oriTrapTFTPOperationInitiated TFTP operation Initiated Informational
oriTrapTFTPOperationCompleted TFTP operation completed Informational
Trap Name Description Severity Level
oriTrapZeroSizeImage Zero size image loaded onto device Major
oriTrapInvalidImage Invalid image loaded onto device Major
oriTrapImageTooLarge Image loaded on the device exceeds the size
limitation of flash
Major
oriTrapIncompatibleImage Incompatible image loaded onto device Major
oriTrapInvalidImageDigitalSignature Image with invalid digital signature is loaded onto
device
Major
Trap Name Description Severity Level
oriTrapSNTPFailure SNTP time retrieval failure Minor
oriTrapSNTPFailure SNTP sync-up failure Minor
Trap Name Description Severity Level
coldStart AP is on or rebooted Informational
linkUp AP's Ethernet interface link is up (working) Informational
linkDown AP's Ethernet interface link is down (not working) Informational
Trap Name Description Severity Level
New Root AP has become the new root in the Spanning
Tree network
Informational
topologyChange Trap is not sent if a newRoot trap is sent for the
same transition
Informational
