Addressing media
\text\etd\DA615/address
3.8 DA615 instruction manual
Adjusting the print position
Before inserting the medium, you must decide how you wish to position the address
on your medium and how this can be done within the print area of the printer.
Address-block
rotation
The direction of printing depends on the size of your print area. If the
cartridge cannot reach the desired upper margin, then the address
block must be rotated by 180° together with its left margin.
– You can rotate the address block in programming mode (see Sect.
5) in the "ORIENTATION" menu by selecting between “Nor“ and
“Rev“. The selected position can be read from the display.
The address block can contain up to 12 lines.
The display shows:
Left margin The left margin is the spacing between the print area edge and the first
printed character, when the address block direction “REV“ and the
media transport direction “Def“ are set.
The default setting for the margin is 0 mm.
– If you wish to set a different value, you may select a margin of 0-
304 mm in the "Left Margin" menu in programming mode (see
Sect. 5).
Clearance The clearance is determined by the position of cartridges H1/H2 or
H3/H4.
To be quite sure, check your print position settings by performing a print test (see
next page).
