Annex E -Accessories
\text\etd\DA615\Accessories
E.2 Annex DA615
Pinwheels
To avoid smudging of ink by the contact rollers, simply replace the hold-down units
with contact rollers positioned immediately after the print-heads by equivalent ones
with pinwheels.
To do so, replace hold-down set 3 – 4 by set 5 – 6 (Accessories!). The order
numbers of these hold-down units are given in the variant list.
If the printer is set for the opposite transport direction, hold-down set 9 – 10 must
be replaced by set 11 – 12 (Accessories!).
To do this, refer to the second and fourth sections of the variant list.
Switch the printer off ! Remove the two hexagon-socket screws (see arrow in left
diagram) of each hold-down unit and replace it by the corresponding hold-down unit
with pinwheels.
Paper guide
If you are using large formats with small print areas, adjust the paper guide (20) to
avoid a smudged print-out.
Note that the direction of the arrow must correspond to the direction set for the
medium feed.
