ASSEMBL Y
PARALLEL
LiNK
HINGE
PIN
FIGURE 7
FRONT
REAl AXLE
HINGE
6,_ Mower Installation
Your 38" mower installs .without the use of tools.
Raise lift lever (Fig. 10) to its highestposlrion.
Turn height adjustment knob (Fig. 9) to its
lowest position. , . .
eo Slide mower under tractor, discnarge guard to
R.H, side,
b. Install front hinge pin through axle and parellel
link (Fig. 7). Secure wfth retaine_ spdng_
c. Install rear hinge pln through mower lift brack-
ets and parallel link (Fig, 7J. Secure with
retaln er spring.
d. Install clutch rodin clutch lever (Fig. 8. Inset)o
eo Move lift lever forward to lower suspension
arms. Slide trunnlons through lift bracket
holes end secure with retainer ;pring (Fig. 8).
f Roll belt over engine pulley. Make sure belt
is inside belt guides [Fig. 9)_ See belt drive sc-
hematlc decal on mower housing.
g. Use lift lever (Fig. 10} to raise mower,
h. Turn height adjustment knob (Fig. 9} clockwise
(f-_) to the middle of its travel
7. Mower Drive Belt Removal
NOTE: MOWER BELT iNSTALLATION DECAL
LOCATED ON MOWER HOUSING.
REPLACE ONLY WITH THE BELTS SPECIFIED IN
THIS MANUAL.,
TRU_NtON
FIGURE e
\
a, Place attachment clutch lever in "DISEN.
GAGED" positton (Fig. 10)..
b. Torn height adjustment knob (Fig. 9] to lowest
position. Move mower rift lever (Fig. lO)
forward to lower mo war to its lowest position.
co Roll belt off engine pulley (Fig, t 1). Be care-
ful not to bend the belt guides,
d, Pull belt off both mandrels (Fig. ! 1).
e. Spring belt guide away from idler pulley and
pull belt off idler pulley,
f. Slide belt from under idler spring.
8, Mower Drive Belt Replacement
ao Slide belt under extension spring (Fig, 11).
b, Place belt on rearstde of both mandrels,
c_ Spring idler bait guide away from idler pulley
and p/ace belt around mar st'de of idler pulley,
d. Roff belt over mower drive pulley. Make sure
drive belt is inside mower drive pulley belt
guides.
NOTE: BELT GUIDE TO BELT CLEARANCE SHOULD
BE MAINTAINED AT 5/32 TO 1/4'L
FIGURE 9
I0
