62
Inserting and changing the battery
Ǡ Slide the cover of the battery compartment ¿ in the direction of the
embossed arrow until it clicks audibly.
Ǡ Open the cover.
Ǡ Insert the 9 V PP3 battery (IEC 6 LR 61). Please observe correct polarity
when inserting the battery.
Ǡ Close the battery compartment.
Ǡ To remove the battery, push the small red lever Ƹ in the battery
compartment towards the bottom side of the transmitter.
Note:
We recommend powering the transmitter by a standard PP3 alkaline
battery. If powered by a rechargeable 9 V battery, the operating time
will be drastically reduced.
Connecting the antenna
Ǡ Screw the antenna ³ onto the antenna socket (M3 connection).
Connecting the microphone/line cable
Electret powering (“plug-in” power) is available at the AF input for powering
the microphone.
Ǡ Connect the 3.5 mm jack plug ƹ from the microphone/line cable to
the AF input (MIC/LINE) ᕦ.
Ǡ Lock the jack plug by screwing down the locking ring ƺ.
Switching the transmitter on/off
Ǡ Slide back the cover plate ´.
Ǡ Press the ON/OFF button ¾ to switch the transmitter on. The red
LED lights up.
Ǡ To switch the transmitter off, press the ON/OFF button until “OFF”
appears on the display. You can then release the button. The red LED
goes off.
Muting the transmitter
Use the MUTE switch ᕧ to noiselessly mute the transmitter’s audio signal
(this switch does not switch off the transmitter).
